Autoclave Tomy Sx700 Manual Best 〈Best - 2024〉
Print out the sterilization data (temperature, pressure, time) to verify the sterilization cycle was completed correctly. Regularly Check the Lid Gasket
This comprehensive operating guide decodes the technical parameters, step-by-step cycle execution, and critical troubleshooting frameworks found across the official TOMY SX-Series Operator's Manual to ensure your lab maintains the absolute best sterilization performance. Technical Specifications Matrix
TOMY SX-700 is a high-capacity, 69-liter top-loading autoclave designed for versatile laboratory sterilization. Key features include: sterilizers.com Top-Open Lid with Foot Pedal One-Handed Operation
This is a synthesized guide based on common features of the Tomy SX-700. You must refer to the original physical manual that came with your specific unit (or a verified PDF from Tomy/Amerex) for exact instructions, as serial numbers and optional features may vary. autoclave tomy sx700 manual best
If steam escapes from around the rim during a cycle, stop the unit, wait for pressure to drop to zero, open the lid, and inspect the silicone gasket. If the gasket is cracked or deformed, it must be replaced.
: Specifically designed to prevent "sudden boiling" of media or solvents through automatic, gradual pressure reduction. Multiple Modes
Here are several ways to obtain it:
Never sterilize laboratory waste and clean instruments in the same load to avoid cross-contamination.
The SX-700 excels in handling large volumes, capable of holding up to in its vertical chamber.
Beyond the basic instructions, these "best" practices will keep your SX-700 running like new: Key features include: sterilizers
105°C to 135°C for sterilization; 45°C to 95°C for heating/warming. Maximum Operational Pressure: 0.25 MPa (MegaPascals)
| Frequency | Action | Instructions | | :--- | :--- | :--- | | | Check water level | Refill reservoir with distilled water. | | Weekly | Clean the door gasket | Wipe with a soft, damp cloth; check for cracks. | | Monthly | Clean the strainer | Remove and clean the water intake filter inside the chamber. | | Every 50 cycles | Descaling | Run a "Clean" cycle with Tomy descaling agent (or citric acid). | | Every 6 months | Replace air filter | Located behind the front panel. |
Do not force the lid open if the display shows any residual pressure or if the temperature is above 80°C (for liquids) or 97°C (for solids). If the gasket is cracked or deformed, it must be replaced
Need immediate help? Leave a comment below with your SX-700 error code, or check the official Tomy support forum. Never guess with sterilization—your research depends on it.