Eliwell Sb655 C Manual Now

Programming the Eliwell SB655 C involves two primary menus: the (for daily adjustments) and the Factory/Installer Menu (protected by a password to prevent unauthorized adjustments to critical system behaviors). Changing the Temperature Setpoint

Typically 230Vac or 12V cold-use models (verify your specific suffix label).

Eliwell SB655 C Manual: Comprehensive Installation, Configuration, and Troubleshooting Guide

Note: For 12/24Vac models, refer to model suffix. eliwell sb655 c manual

Connect the main power supply to the designated terminals (verify voltage requirements on the side label of the instrument before applying power).

Solution: Verify compressor relay functionality to ensure contacts are not stuck in the closed, permanently energized position.

: Management of Scroll/Semi-Hermetic/Screw compressors, automatic summer-winter changeover, and Modbus/Televis compatibility. Electric Automation Network Quick User Operations Instructions View Setpoint Press and release the Change Setpoint arrows while the setpoint is displayed and confirm with Manual Defrost Press and hold the key for 5 seconds. Reset Alarms Navigate to the menu, then , and press for 3 seconds. for this specific model? Programming the Eliwell SB655 C involves two primary

| Code | Description | Range | Default | |------|-------------|-------|---------| | | Minimum alarm threshold | -50 – AH | -40 | °C | | AH | Maximum alarm threshold | AL – 110 | 50 | °C | | Ad | Alarm delay | 0 – 255 | 30 | minutes | | Ab | Alarm relay function (if avail) | 0=No, 1=Yes | 0 |

If the display shows an error instead of a temperature, refer to these common Eliwell codes:

IP65 front panel protection when installed with the provided rubber gasket. Inputs and Outputs (I/O) Configuration Connect the main power supply to the designated

The Eliwell SB655 C is suitable for a wide range of industrial applications, including:

Press and hold the key for 3 seconds until the display flashes the first parameter folder code (typically CP ).

If the parameter LOC is set to y (yes), the setpoint cannot be changed by the user. If a password is set, you will be prompted to enter it when trying to access the Programming menu. This is indicated by a display showing PA1 (or PA2 for the second level).

Indicates the compressor is active. Flashing means a start delay is active. Fan Icon: Indicates the evaporator fans are running.