Plug the ISP adapter into your Easy-JTAG Plus Box and connect the box to your PC. Step 2: Configure Easy-JTAG Plus Software Launch the on your computer.
The process can disable Knox protection.
Use Odin or the Easy-Jtag flashing tool to flash a clean, official Samsung stock firmware matching the device's original binary version.
Before proceeding, you must understand the implications of this process:
Adjust the voltage settings (usually and VCCQ = 1.8V or 2.8V depending on stability). Set the bus width to 1-bit for ISP. Click Connect Direct to eMMC/UFS . samsung kg lock remove easy jtag
Click "Identify" to check if the connection is successful. If successful, you will see device partition information.
Once a successful connection is established in the Easy JTAG Plus software interface, data preservation is critical to avoid hard-bricking the phone.
To modify the storage chip without removing it from the board, you must use the ISP method.
Always verify local legal guidelines regarding device ownership verification before performing hardware modifications on security locks. Plug the ISP adapter into your Easy-JTAG Plus
: A clean, matching binary-level stock ROM or special MDM removal files. Phase 1: Hardware Connection (ISP or Direct Chip)
There are two primary methods used by technicians to neutralize the KG lock depending on the device generation:
Shorten the ISP jumper wires under 5cm; connect an external DC power supply to the phone board.
Samsung Knox Guard (KG) lock removal using typically involves hardware-level modification of the device's eMMC or UFS memory. This process is highly technical and generally targets older or specific models where ISP (In-System Programming) or direct chip connection is possible. General Process for KG Removal via Easy JTAG Use Odin or the Easy-Jtag flashing tool to
Connect the Easy-Jtag Plus box to your computer via a high-speed USB port. Step 2: Initialize and Detect the Storage Chip Launch the software on your PC.
What is the of the Samsung phone (e.g., SM-A042F)? Does it have an Exynos or Qualcomm processor?
Under a microscope, apply a tiny amount of flux to the ISP points on the motherboard. Solder fine jumper wires to .