Usb Device Id Vid 14cd Pid 1212- Jun 2026

If the upper/lower filter drivers are corrupted:

If the device is not working or you need to verify it's the correct hardware, follow these steps:

Then, unplug and re-plug the device.

This ID is often linked to adapters that show up as a drive but report "No Media" if the microSD card is faulty or not seated correctly. Usb Device Id Vid 14cd Pid 1212-

It is typically a small, inexpensive adapter used to connect microSD cards to a computer via a USB port. Driver Information

So, almost always points to a generic, multi-format memory card reader . This reader typically supports:

[SuperTop.NTamd64] %DeviceDesc%=CC_Install, USB\VID_14CD&PID_1212 If the upper/lower filter drivers are corrupted: If

The USB Device ID VID 14CD PID 1212 corresponds to a low-cost, generic microSD card reader. While it is widely supported by all major operating systems using native drivers, its hardware limitations can lead to specific technical issues.

If you're writing an article about troubleshooting, the most frequent user complaints are:

The USB Device identifier corresponds to a mass storage controller manufactured by Super Top (also known as Moai Electronics Corporation). It is most commonly found in generic microSD card readers , specifically models like the SY-T18 . Technical Specifications Vendor ID (VID): 14CD (Super Top / Moai Electronics Corp). Product ID (PID): 1212 (microSD Card Reader). Protocol: USB 2.0 (High Speed). Max Current: Typically 100mA to 200mA. Driver Information So, almost always points to a

Assigned by the vendor, this 16-bit value identifies the specific model architecture. Code 1212 indicates their standard High-Speed USB 2.0 Mass Storage Controller , most famously packaged inside micro-sized USB-to-microSD dongles. Technical Specifications and Performance Expectations

Devices using this ID usually follow these technical parameters: : USB 2.0 (High Speed). Current Draw : Typically between 100mA to 200mA .

Most VIA devices are supported natively by Windows. If yours isn't working, follow these steps: