The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.
Email
Ultimate ATS-20 Radio Manual: Setup, Operation, and Expert Tips
Electronics like routers, LED bulbs, and PC monitors cause heavy RF noise. Move near a window.
What are you trying to receive (Ham operators, shortwave broadcasters, or local FM)? Are you using the stock whip antenna or an external setup? ats-20 radio manual
If you have a kit, you will need to solder the two push‑button switches, the graphic OLED, the rotary encoder, and the Nano reset switch. All other components (including the Si4732 chip) are typically already soldered to the board.
The ATS-20 SDR receiver is a testament to the power of open-source hardware and community-driven development. While its "manual" is not a single, static document, but rather a collection of GitHub pages, forum posts, and enthusiast guides, mastering this radio is an achievable and highly rewarding journey. Ultimate ATS-20 Radio Manual: Setup, Operation, and Expert
Which you are trying to listen to (FM, Shortwave, or Amateur SSB)?
Cycles through tuning increments. Available steps vary by mode (e.g., 1kHz, 5kHz, 9kHz, 10kHz, 100kHz). Are you using the stock whip antenna or an external setup
Connect a simple insulated wire (10 to 20 meters long) draped outdoors or high up in trees to the center pin of the BNC connector. This drastically improves SW reception.
Flip the physical power switch located on the side panel to the position.
The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.
