Företag
Privat
SEKExkl. moms
PRODUKTER
Kundvagn
PRODUKTER
Allacategory select open arrow
Kundvagn

Elfa Distrelec blir RS – dags att flytta över!

Vi är mitt i övergången till RS, där ditt konto, dina priser och vår service snart kommer att finnas tillsammans med ett ännu bredare produktsortiment, fler servicelösningar och en dedikerad hemsida på svenska. Flytten och nedstängningen av Elfa Distrelecs hemsida förväntas vara klar under Q1, och vi kommer snart kontakta dig med mer information. Gå till RS

Circutor Computer 8d-96 Manual -

The section of the manual details the necessary wiring for the Current Transformer (CT), voltage measurement, and the capacitor bank's contactors. Each piece of information is designed to guide the user in setting up a safe and functional electrical system. You'll also find a section dedicated to Installation Methods , which outlines the different physical mounting options for the regulator.

Other configurable items include connection and reconnection times, the total number of output relays, and settings for alarms.

October 26, 2023 Subject: Operational Overview and Feature Analysis of the CIRCUTOR Computer 8D-96

Safety is paramount during installation. Ensure the entire electrical panel is completely de-energized before mounting the device. circutor computer 8d-96 manual

For full technical specifications, please consult the complete Circutor Computer 8D-96 manual.

Includes user-programmable setup for target power factor, hysteresis, and step reconnection times.

Slide the included side-fixing clips into place and tighten the screws until the unit is flush against the panel. Wiring Architecture The section of the manual details the necessary

: Ensure the facility is drawing power, or verify the CT secondary wires on Terminals 5 and 6 are not open-circuited. 2. Over-compensation (Capacitive Reading) Cause : Target cos

Wire the output terminals in series with the contactor coils of your capacitor steps. Use a common fuse-protected auxiliary line to power the contactors through the regulator's internal relays. 3. Programming and Configuration

Before placing the unit in automatic mode, you must program the core system parameters. Enter the setup menu by pressing and holding the key for a few seconds. Step 1: Setting the CT Ratio its corresponding LED will illuminate

The front panel consists of a digital LED display and a set of tactile push-buttons used for monitoring and configuration. Display Indicators Displays the instantaneous Power Factor ( ), current, or programmable parameters.

Press the arrow key to manually discharge and turn off individual steps. Return the unit to Automatic Mode for daily operations. 5. Troubleshooting and Fault Status Codes

Press the arrow key. Relay 1 will energize, its corresponding LED will illuminate, and you should hear the physical contactor close. Press (+) again to sequence through the next steps.

The device can be configured and monitored using Circutor's proprietary software. The software allows users to:

The front panel consists of an LED screen and a keypad designed for intuitive navigation, as detailed in the Computer-8d-96 manual. 3.1 Initial Setup (Startup Screen)