Note the exact spot where the audio tone is loudest and the view meter peaks.
Plug the cable interface into the socket on the back of the control housing. Turn the outer ring clockwise to lock it in place. Control Panel Functions
Extend the adjustable stem to a comfortable length and secure the search coil. Ensure the cable is wrapped loosely around the shaft to prevent signal interference or cable strain. Orbitor Prospector 100 Metal Detector Manual
Built-in speaker with a 1/4-inch headphone jack for silent operation.
The needle sweeps right when a target is detected. The strength of the sweep indicates the proximity and size of the metal object. 4. Battery Installation and Maintenance Note the exact spot where the audio tone
The Prospector 100 requires two high-quality 9V alkaline batteries.
: Store in normal temperature environments to protect the electronic circuits. Control Panel Functions Extend the adjustable stem to
Insert the lower shaft into the search coil bracket. Align the mounting holes and secure them with the bolt and large plastic thumb knob. Tighten the knob by hand until the coil is secure but still allows slight pivoting for adjusting the search angle.