Ivoclar Programat P95 Manual -

Fits easily on standard laboratory benches (approx. 280mm x 400mm x 420mm). Weight: ~13 kg (28.6 lbs). Component Anatomy

Ignoring this section leads to under-fired (porous) or over-fired (over-glazed, sharp edges) restorations.

Always allow the furnace to reach its standby temperature (usually 403°C) and hold for at least 10 minutes before starting the first cycle of the day. This eliminates residual moisture inside the insulation. Firing Cycle Select the desired program.

The furnace will automatically execute the drying phase ( S ), close the head, ramp up the heat ( t↑ ), activate the vacuum pump ( V1 to V2 ), hold at peak temperature ( H ), vent the vacuum, and lower the temperature. Ivoclar Programat P95 Manual

Place your prepared crown, bridge, or veneer on a firing tray using custom firing pins. Place the tray onto the furnace insulation table.

The Ivoclar Programat P95 is a testament to quality engineering. By following the safety and maintenance guidelines

Place your prepared ceramic restoration onto a firing tray utilizing a firing pillow or metal peg. Ensure the restoration does not touch the thermocouple or the inner walls of the chamber. Initiate: Press the START button. Automatic Cycle: The P95 will execute the drying time ( Fits easily on standard laboratory benches (approx

Press the button. The furnace head will automatically descend according to the set closing time ( S ).

Plug the Ivoclar-approved vacuum pump into this dedicated outlet. Do not plug the pump directly into a wall outlet, or the furnace cannot automate the vacuum cycles.

Use the number keys or the arrow keys to choose an open or adjustable program slot. Component Anatomy Ignoring this section leads to under-fired

Check the rubber ring seal around the lift platform. Tighten hose clamps. Change vacuum pump oil. Broken quartz heating element or failed solid-state relay.

Press or Store to save the changes to that specific program. Repeat for all parameters. 4. Standard Operating Procedures (SOP)

Here is what you will find in the official documentation and why each section matters.

Test the resistance of the heating element. Replace the quartz heating muffle if the circuit is open. Inaccurate calibration or improper placement.

Privacy Preference Center