Solid: Power supply is within acceptable voltage parameters. Off: No power or internal fuse failure.
💡 For detailed wiring diagrams, refer to the Friendess BCL4562 Guide or the official FSCUT selection guide . If you'd like, I can help you:
Connect the +24V DC positive wire to Terminal 1 (labeled V+) and the ground/negative wire to Terminal 2 (labeled V-). Connect Terminal 3 (PE) to your system’s physical earth ground.
Check input voltage with a multimeter. Verify wiring polarity matches the terminal diagram. Internal watchdog timer error or hardware failure.
| Item | Model | Quantity | Description | | :--- | :--- | :--- | :--- | | | BCL4562 | 1 | The main interface board. | | PCI Control Card | BMC1603 | 1 | The main controller card. | | Control Card Cable | C62 series (2m/5m/10m) | 1 | Connects BMC1603 to BCL4562. | | Servo Cables | C15 series (1.5m/2.5m/4m) | 4 | For X/Y1/Y2/Z servo drives. | | Handheld Remote | WKB V6 | 1 | Wireless pendant for manual control. | | RF Cables | SPC-140/180 (140mm/180mm) | 2 | For remote and radio communication. | | Network Cable | LAN-3X/7X/17X (3m/7m/17m) | 1 | For network communication with the laser. | | Aviation Plug Cable | HC-15/20 (15m/20m) | 1 | For connecting to the height controller or other peripherals. | bcl 4562 manual
Compatible with WKB series wireless hand-held remotes for manual machine operation. Installation & Wiring Highlights
To ensure the long-term reliability of your BCL 4562 controller, follow these industrial maintenance guidelines:
Apply power while continuing to hold the button for 10 seconds.
: Produce a 0–10V analog voltage that dictates peak laser output scaling and controls electronic auxiliary gas proportional valves. Step-by-Step Wiring Instructions Solid: Power supply is within acceptable voltage parameters
Wire a dedicated switching power supply to the main power terminal inputs.
Indicates normal microprocessor runtime operation. A solid red light points to an internal memory or hardware architecture failure.
To help you find the , here’s what you can do:
Press and hold the recessed button located near the USB port using a small pin. If you'd like, I can help you: Connect
The display will show Full . Enter the maximum weight capacity of your scale using the keypad. Press [ENTER] .
Includes ports for servo control, limit signals, and laser modulation (PWM). Environmental Constraints Temperature: Operates between 0°C and 55°C . Humidity: 5% to 95% RH (non-condensing).
Check all visible wire connections for discoloration or oxidation. Replace damaged wires instantly to avoid high electrical resistance.
Subtracts the current container weight, switching the display from Gross to Net weight.