Open the panel (the 'P' button on the left sidebar) and type ESP32 into the search bar.
: Version 8.12 or higher is highly recommended, as older versions lack stable support for advanced microcontroller libraries.
: Paste a standard blink sketch into the editor: proteus esp32 simulation
Simulate peripherals separately:
#define LED_PIN 2 void setup() pinMode(LED_PIN, OUTPUT); Serial.begin(115200); void loop() digitalWrite(LED_PIN, HIGH); Serial.println("LED IS ON"); delay(1000); digitalWrite(LED_PIN, LOW); Serial.println("LED IS OFF"); delay(1000); Use code with caution. 2. Compile and Locate the Binary Open the panel (the 'P' button on the
If your code attempts to connect to a Wi-Fi network ( WiFi.begin() ), the simulation may hang or the virtual microcontroller will simply fail to find a network. Proteus does not currently have a virtual router or TCP/IP stack environment to simulate internet connectivity.
Simulating the ESP32 in Proteus is a fantastic way to prototype logic and test GPIO wiring before soldering a single wire. While it may not perfectly replicate Wi-Fi transmission, it saves hours of debugging time for basic control systems and sensor interfaces. Simulating the ESP32 in Proteus is a fantastic
Proteus and search for "ESP32" in the component picker. ⚡ Professional Utility
To see the ESP32 module in the "Pick Devices" list, you need to add third-party library files.