Ts1162 Installation Manual -

Drill, screwdriver set, wire strippers, and a multimeter. 3. Installation Procedures

Connect the leads of the included NTC thermistor or PT100 probe. Sensor wires do not have polarity, so either wire can go into either terminal.

Check the RS-485 LAN connections and ensure the DIP switch address does not conflict with another device.

Ensure the unit is properly grounded to prevent electrical interference. 6. Configuration and Calibration ts1162 installation manual

Ensure the Challenger system can support the additional current draw of the keypad.

The model number "TS1162" appears in the specifications for a range of disparate items, from a 3M electronic connector to a WeatherTech car sunshade, and even a bucket of terrazzo flooring mix from Germany. If you are here for an , you are very likely looking for the TS1162 3-LED Keypad used in professional security systems.

Tecom TS1162 is a robust 3-LED Remote Arming Station (RAS) keypad used primarily with Challenger security systems. Because detailed installation and programming manuals for Tecom hardware are often restricted to trained installers, they can be difficult to find on public websites. support.firesecurityproducts.com.au Key Technical Details for Installation Drill, screwdriver set, wire strippers, and a multimeter

: Secure the base to a flat, solid surface using the provided mounting holes.

The TS1162 supports both Direct Thermal (no ribbon required) and Thermal Transfer (ribbon required) printing styles. Loading Label Rolls

Pro Tip: Avoid loops of wire inside the enclosure and use cable ties to secure wires near the point of entry to maintain a clean, secure installation. 4. Addressing and Configuration Sensor wires do not have polarity, so either

Separate low-voltage signal wires from high-power AC wires by at least 10 cm (4 inches). Use shielded twisted pair for analog inputs and ground the shield only at one end (controller side).

: Turn off all power to the Challenger panel before wiring.

This article provides a structured overview based on typical Tecom installation guidelines, serving as a guide for technicians and installers. 1. Pre-Installation and Safety