This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Run manually. If the cable is recognized, go to the Update tab and try to "Check for Updates" to force a firmware reset. Critical Safety Tips
Highly prone to unbricking via an EEPROM programmer if the chip is not write-protected. 🛑 Common Failure Symptoms
Plug the ST-Link V2 programmer into your computer's USB port. Launch the software.
Locate the 6-pin ISP header on the HEX-V2 PCB. It is usually near the ATMEGA162 chip. If missing, solder wires directly to the MOSI, MISO, SCK, RESET, VCC, and GND pins. vcds 2231 hex v2 clone repair updated
Inside the VCDS software options, go to the Options > User Interface and Identification tab. Set the "Check for Updates" drop-down menu to Do not check for updates .
Never click "Check for Updates" inside the software. Never run VCDS 23.3 or higher on a clone—the encryption changed, and the loader fails, bricking the interface instantly.
Your ATMEGA flash is correct, but your FTDI EEPROM is wrong. Repeat Step 5 (Mprog). Set the string descriptor to "Rosstech USB."
Once your VCDS 22.3.1 clone is operational, protect it from being blocked again by adopting these habits: This public link is valid for 7 days
Disable and any third-party antivirus software, as clone loaders are often falsely flagged as malware. Step 2: Clear Corrupted Firmware (Using VCI Cleaner)
Needed to rewrite the chip if your computer completely ignores the cable.
Ross-Tech actively counters clone usage. If you contact their support with an "Interface Not Found" error, their official response is almost always:
Locked to specific software versions (often requires a loader like VIIPlusLoader or VCDSLoader). Can’t copy the link right now
Install but do not run it after installation finishes.
| USBasp Pin | HEX-V2 ISP Header | ATMEGA162 Pin | | :--- | :--- | :--- | | Pin 1 (MISO) | Pin 1 | Pin 18 (PDO) | | Pin 2 (VCC) | Pin 2 | Pin 20 (VCC) | | Pin 3 (SCK) | Pin 3 | Pin 11 (PB1) | | Pin 4 (MOSI) | Pin 4 | Pin 17 (PDI) | | Pin 5 (RESET) | Pin 5 | Pin 9 (RESET) | | Pin 6 (GND) | Pin 6 | Pin 22 (GND) |
Set the fuse bits according to your specific chip documentation to lock the bootloader from future deletion. Step 3: Clean Install VCDS 22.3.1