Xh-m608 Manual -

The is a versatile DC 6-40V battery charge and discharge controller module designed to protect various batteries (like lithium and polymer) from over-voltage and under-voltage conditions. It features an integrated voltmeter for real-time monitoring and a relay output to control external charging or discharging circuits. Key Specifications Input Voltage: DC 6.0V to 40V. Voltage Accuracy: Display and control accuracy of 0.1V0.1 cap V

Supports undervoltage protection, overvoltage protection, charging control, and discharging control. 2. Menu Functions (P-Codes) To enter the settings menu, long press the SET button for approximately 3 seconds. Use the (+/-) buttons to cycle through the menu and press briefly to enter a specific setting.

When operating under , long-pressing the DEC button from the main screen displays the remaining active countdown timer. 4. Performing a Factory Hard Reset Xh-m608 Manual

A.00 is disabled. Set from 0.01 to 9.59 for timed charging/discharging.

The trigger terminals carry a low-voltage logic signal (5V). Do not apply mains voltage to these terminals. The is a versatile DC 6-40V battery charge

Use this mode to prevent battery overcharging. The module connects a battery charger to the battery.

Use or - to set the voltage where charging should stop (e.g., 14.4V for a 12V battery). Hold SET for 3 seconds to save. Setting Up Discharge Protection (Mode 2) Press SET . The display shows P1 . Press + or - to change the value to 2 . Press SET to access P2 (Lower voltage limit). Voltage Accuracy: Display and control accuracy of 0

is a versatile battery management module designed to automate the charging and discharging cycles of batteries within a 6V to 40V DC

Carefully remove the device from its packaging and inspect for any visible damage. Make sure all the included accessories are present.