Update 2021 — Mtcc-kld6-v3.06

Before flashing any files, verify your and MCU Version in the "About Device" section of your settings. MTCC units are a specific evolution of the MTCB/MTCD family; installing firmware meant for a different board can "brick" the unit, rendering it a paperweight. Always ensure the update file is specifically labeled for the KLD (Klyde) manufacturer prefix. The Installation Process

The sensitivity can be tuned via new system register SYS.BNV.THRESHOLD (default 18.5V, adjustable down to 16.0V via the param.cfg file).

MTCC has confirmed that V3.06 is a with support guaranteed until December 2028. The next major release (V4.00) is scheduled for Q2 2026 and will introduce: Mtcc-kld6-v3.06 Update

| Payload Size | v3.05 IPC latency (µs) | v3.06 ring mode (µs) | Throughput gain | |--------------|------------------------|-----------------------|------------------| | 128 B | 2.1 | 2.0 | 5% | | 1 KiB | 7.8 | 2.9 | 169% | | 16 KiB | 48.2 | 5.1 | 845% | | 1 MiB | 1,890.0 | 22.4 | 8339% |

file via a FAT32-formatted SD card, often associated with Pumpkin units. Find more details and community support at AutoPumpkin Forum Before flashing any files, verify your and MCU

Once completed, the system will say "Update Successful". Manually select from the recovery screen. Pull your SD card out during the reboot sequence to prevent the device from trying to flash the file in an infinite loop. Critical Troubleshooting Tips

: Go to Settings > About Device . Look for the "MCU Version" string. Ensure it starts with MTCC-KLD6 . The Installation Process The sensitivity can be tuned

Once finished, go back to to verify the MCU version now reads KLD6-v3.06 (or similar). Troubleshooting

Copy the file directly to the of your storage drive. Do not place it inside any folders. 4. Execute the Flash Process